More Misc Tank work

Here is a picture of the anti-hangup bracket. I'm not sure if I posted a picture of it. It just keeps the flop tube from getting stuck between the stiffener, and the rib.


The fuel level sender wire gets wrapped around the vent tube and then sealant is applied to hold it in place.

Here is the inboard most rib, and I've wrapped the wire around the vent tub. Next time I think I'm going to wait on installing the BNC connector until everything is completed. It was a little challenging getting the sealant on the rib with the wire in the way.
f

The inboard rib is now cleco'd on waiting for its ~24 set up time. The hole at the bottom of the picture is for the flop tube.